| Tittel: | KXP 750/750A TRANSPONDER : MAINTENANCE MANUAL | | Materialtype: | Manual/Sivil | | Signatur: | 20-A-2 | | Utgitt: | OLATHE, KANSAS : KING RADIO CORPORATION, TECHNICAL PUBLICATIONS DEPT., 1966 | | Emneord: | King Radio / KXP 750 transponder / Maintenance manual | | Materialbetegnelse: | Technical Handbook | | Materialbetegnelse: | Perm | | Note: | Published in April 1966. Last Revision No. 5, Revision Date June 1972 | | Innhold: | TABLES OF CONTENTS:
KXP-750
SECTION I - GENERAL INFORMATION
1.1 Introduction
1.2 Performance Specifications
SECTION II - INSTALLATION
2.1 General
2.2 KXP-700 Installation and Location
2.3 KRA-580/585 Installation and Location
2.4 KFS-570 Installation and Location
2.5 KA-27 Antenna Installation
2.5.1 Location Considerations
2.6 Operation
2.7 Electrical Installation
SECTION III - CIRCUIT THEORY
3.1 General Theory
3.1.1 RF Section
3.1.2 IF Amplifier
3.1.3 Video Amplifier
3.1.4 Ditch Digger
3.1.5 Video Switch
3.1.6 Noise/Suppression Coincidence
3.1.7 Delay Line Driver
3.1.8 Decode Delay Line
3.1.9 SLS Coincidence
3.1.10 SLS Gate Generator
3.1.11 "A" and "C" Decode Coincidence
3.1.12 "A" or "C" Reply Select and Inhibit Circuits
3.1.13 Reply Gate Generator and Suppression Output Amplifier
3.1.14 AOC Counter and Control Amplifier
3.1.15 Burst Generator and Clock Pulse Trigger
3.1.16 Encoding Flip-Flops and Encoding Matrix
3.1.17 Code Selection Circuits
3.1.18 "A" and "C" Reply Coincidence
3.1.19 Modulator and Transmitter
3.2 Detailed Circuit Description and Analysis
3.2.1 Radio Frequency Stripline Assembly N-101
3.2.2 Local Oscillator
3.2.3 IF Amplifier and Successive Detection
3.2.4 Video Amplifier
3.2.5 Ditch Digger and the Video Switch
3.2.6 Noise Spike and Suppression Coincidence
3.2.7 Delay Line Driver and Decode Delay Line
3.2.8 SLS Coincidence and the SLS Gate Generator
3.2.9 Mode "A" and Mode "C" Decode Coincidence and Reply Gate Generator
3.2.10 Burst Generator and Clock Pulse Trigger
3.2.11 Encoding Flip-Flops
3.2.12 Encoding Matrix and Code Selection
3.2.13 A/C Reply Select and Reply Mode Coincidence
3.2.14 IDENT Timing, Turn On Delay, and "ON" Memory
3.2.15 Suppression Output Amplifier and the AOC Counter
3.2.16 Modulator Circuit Board
3.2.17 Cavity Oscillator
3.2.18 Test Function and Reply Lamp Driver
3.2.19 Power Supply
SECTION IV - MAINTENANCE
4.1 General
4.1.1 Test Equipment
4.2 Alignment and Calibration
4.2.1 Power Supply Adjustment
4.2.2 Local Oscillator Tuning
4.2.3 Mixer Diode Test
4.2.4 Complete IF Alignment
4.2.5 Alignment of Last Three IF Stages Only
4.2.6 Transmitter Alignment
4.2.7 Complete Transponder Test Procedure
SECTION V - PARTS LIST
Stripline Section
Cavity Oscillator Section
Local Oscillator Section
IF Circuit Board
Encoder/Decoder Circuit Board
Modulator Circuit Board
Power Supply Section
KFS-570
Installation and Bench Test Kit
SECTION VI - ILLUSTRATIONS AND SCHEMATICS
BLOCK DIAGRAM 6-12
R.F. POWER SUPPLY I.F. 6-13
LOCAL OSCILLATOR SECTION 6-15
I.F. SCHEMATIC 6-16
ENCODER/DECODER SCHEMATIC 6-17
MODULATOR SCHEMATIC 6-18
POWER SUPPLY SCHEMATIC 6-19
KFS-570 SCHEMATIC 6-20
KXP-750A
SECTION VII GENERAL INFORMATION
7.1 Introduction
7.2 Technical Characteristics
7.3 Operation
SECTION VIII INSTALLATION
8.1 Unpacking and Inspecting Equipment
8.2 Installation Procedure
8.3 KFS 570A Installation
8.4 KA 28 Installation
SECTION IX CIRCUIT THEORY
9.1.1 Video Amplifier
9.1.2 Noise Suppression Coincidence
9.1.3 Ditch Digger
9.1.4 Test Circuit
9.1.5 Receiver Suppressor
9.1.6 Altitude Reporting "ON-OFF"
9.1.7 Power Supply
SECTION X MAINTENANCE
10.1 General
10.1.1 Test Equipment
10.2 Alignment and Calibration
10.2.1 Power Supply Adjustment
10.2.2 Local Oscillator Tuning
10.2.3 Mixer Diode Test
10.2.4 IF Alignment
10.2.5 Alignment of Last Three IF Stages Only
10.2.6 D/E Board Test Procedure
10.2.7 Cavity Oscillator Alignment
10.2.8 Complete Transponder Test Procedure
SECTION XI PARTS LIST
SECTION XII DIAGRAMS AND ILLUSTRATIONS | | Eier: | Norsk Luftfartsmuseum | | |
|
| 1.ex | Ikke til utlån | | Norsk Luftfartsmuseum | Norsk Luftfartsmuseum | | | |
|
|